Oracle X7-2 - Servicing the Nvme Cables; Remove the Nvme Cable Assembly

Servicing the NVMe Cables
The following section describes how to service the NVMe cables. The NVMe cables are
field-replaceable units (FRUs). For more information about FRUs, see “Illustrated Parts
Breakdown” on page 19 and “Field-Replaceable Units” on page 22.
Caution - These procedures require that you handle components that are sensitive to
electrostatic discharge. This sensitivity can cause the components to fail. To avoid
damage, ensure that you follow antistatic practices as described in “Take Antistatic
Measures” on page 61.
Caution - Ensure that all power is removed from the server before removing or installing the
NVMe cables. You must disconnect the power cables before performing this procedure.
Caution - The NVMe cables should be removed and replaced only by authorized Oracle
Service personnel.
This section covers the following procedures:
■
“Remove the NVMe Cable Assembly” on page 185
■
“Install the NVMe Cable Assembly” on page 189
Related Information
■
“Extend the Server to the Maintenance Position” on page 59
■
“Take Antistatic Measures” on page 61
■
“Remove the Server Top Cover” on page 62
Remove the NVMe Cable Assembly
1.
Prepare the server for service.
Servicing the NVMe Cables 185