Oracle X7-2 Service Manual

Servicing Processors (FRU)
The following section describes how to service processors. Processors are field-replaceable
units (FRUs). For more information about FRUs, see “Illustrated Parts Breakdown” on page 19
and “Field-Replaceable Units” on page 22.
Caution - Ensure that all power is removed from the server before removing or installing a
processor. You must disconnect the power cables from the system before performing these
procedures.
Caution - Processors must be removed and replaced only by authorized Oracle Service
personnel.
Caution - This procedure requires that you handle components that are sensitive to electrostatic
discharge. This sensitivity can cause the component to fail. To avoid damage, ensure that
you follow electrostatic discharge safety measures and antistatic practices. See “Electrostatic
Discharge Safety” on page 50.
Note - On single-processor systems, processor socket 1 (P1) is shipped without a heatsink and
processor filler cover. To protect the delicate processor socket pins, do not remove the processor
cover that was installed on the motherboard.
This section covers the following topics:
■
“Identify and Remove a Faulty Processor” on page 138
■
“Install a Processor” on page 144
Related Information
■
“Disconnect Cables From the Server” on page 58
■
“Take Antistatic Measures” on page 61
■
“Remove the Server From the Rack” on page 61
■
“Remove the Server Top Cover” on page 62
Servicing Processors (FRU) 137

Oracle X7-2 Specifications

General

Processor	Intel Xeon Scalable processors
Number of Processors	1 or 2
Memory	Up to 1.5 TB DDR4
Memory Slots	24 DIMM slots
Form Factor	2U Rackmount
Storage Bays	8 x 2.5-inch
CPU Socket	Socket P (LGA 3647)
Power Supply	Redundant hot-swappable power supplies