Oracle X7-2 Service Manual

Assign Serial Port Output Using the Oracle ILOM CLI
Assign Serial Port Output Using the Oracle ILOM CLI
1.
Open an SSH session, and at the command line, log in to the SP Oracle ILOM
CLI.
Log in as a user with root or administrator privileges. For example:
ssh root@ipaddress
Where ipaddress is the IP address of the server SP.
For more information, see “Accessing Oracle ILOM” in the Oracle X7 Series Servers
Administration Guide.
The Oracle ILOM CLI prompt (->) appears.
2.
To set the serial port owner, type:
-> set /SP/serial/portsharing owner=host
Note - The serial port sharing value, by default, is owner=SP.
3.
Connect a serial host to the server.
Assign Serial Port Output Using the Oracle ILOM Web
Interface
1.
Log in to the SP Oracle ILOM web interface.
Open a web browser and direct it using the IP address of the server SP. Log in as root or a user
with administrator privileges. See “Accessing Oracle ILOM” in the Oracle X7 Series Servers
Administration Guide.
The Summary Information page appears.
2.
In the Oracle ILOM web interface, select ILOM Administration → Connectivity
from the navigation menu on the left side of the screen.
3.
Select the Serial Port tab.
The Serial Port Settings page appears.
Note - The serial port sharing setting, by default, is Service Processor.
4.
In the Serial Port Settings page, select Host Server as the serial port owner.
Troubleshooting and Diagnostics 43

Oracle X7-2 Specifications

General

Processor	Intel Xeon Scalable processors
Number of Processors	1 or 2
Memory	Up to 1.5 TB DDR4
Memory Slots	24 DIMM slots
Form Factor	2U Rackmount
Storage Bays	8 x 2.5-inch
CPU Socket	Socket P (LGA 3647)
Power Supply	Redundant hot-swappable power supplies