Fade Editor : Parameters & Options Section
9 - 203
• Follow TimeLine Display
• Choice of tracks. The number of Tracks selected in the TimeLine controls the available choices. So, if
4 Tracks are selected, there will be the option of 1, 2, 3, or 4 Tracks
• Auto-Center, enables automatic re-centering of the display around the Fade or Reference Point after cer-
tain operations
•None
•Fade
• Reference Point
• Zoom, can be one of the following:
• Free, follows only Zoom Reset, In and Out
• Auto-Zoom, automatically Zooms around the current Fade after some operations
• Auto-Zoom / Free, automatically Zooms around the current Fade but only when it enters the Fade
Editor, thereafter, the Zoom is Free
• Timeline, follows the Timeline Zoom factor
• Choice of User defined Zoom Presets (see menu View > Zoom)
• Waveform Display Can be any of the following:
• Follow Project Settings
•X1
•X2
•X4
•X8
•X16
•X32
•X64
• Auto-Scale Visible
Audition
• Pre-Roll from the choices defined in the Settings > All Settings Application Playback/Record Page
• Post-Roll from the choices defined in the Settings > All Settings Application Playback/Record Page
• Solo, when On only the edited Tracks are auditioned, when Off all Tracks of the composition are audi-
tioned as well
• Loop, any audition operation is repeated until Stop is pressed
• Speed, allows choice between 100%, 50% and 25% of normal play speed for auditioning
• Audition after Nudge, to automatically audition the Fade after nudging any parameter
Memory
• Set, allows saving up to 6 temporary Fades for comparison
• Recall, allows recall of one of the 6 temporary saved Fades
X Presets / Out Presets / In Presets
• Load Curve, allows loading the Curve SHAPE only from a choice of:
• Default
•Power
• Linear
•dB
To Next Page