Appendices : Appendix V - Network Connections
31 - 797
Synchronization with Virtual Transport 2
Synchronization is automatic between Pyramix and VCube(s) listed and connected in Settings > All Settings
> Remote Control > Virtual Transport.
Note: For proper synchronization between Pyramix and VCube in a non MassCore Native mode
PyraCube the ASIO buffer size of the ASIO device should be set to 256 samples. If this is not pos-
sible for the ASIO device then switch the VCube configuration from Platform Native - ASIO to
No VS3/ASIO audio in the VS3 Control Panel. In this case, synchronization between Pyramix and
VCube may take longer, but will work.
To Next Page
Loading...