Mixer : Mixer Configuration from the Mix! page
10 - 249
Panning Control Buses
Access the right-click context menu with the mouse cursor over a blank area in an existing strip. Select Bus > Add
> Panning Control Bus. A new panning control Bus is created in the Mixer.
Input Strips
Select Strip > Add and choose the type of Input Strip to Add from the list below, or choose VCA Group.
•Mono
• Mono - Direct Monitoring
•Stereo
• Stereo - Direct Monitoring
•MS
• MS - Direct Monitoring
• Multi Channel Strip
•VCA Group
Rearranging Strips
Input strips, VCA group strips and Sub-group strips are moved directly in the console UI.
Only Input Strips, Groups and SubGroups can be moved. The Bus Masters Strips cannot.
Using Context Menu:
• Select one or more Strips
• In the right-click context menu choose Strip > Copy Selected Strips
• Select a destination Strip <x>
• In the right-click context menu choose Strip > Move Copied Strips Before <x> or Move Copied Strips
After <x>
Using Drag & Drop:
• Select one or more Strips
• Press Ctrl + Shift + Alt
• Drag the selected Strips onto any other Strips
Note: If a Sub-group or VCA group is not moved, i.e. located at the far right of all the input strips,
it is locked in place when scrolling the input strips. When a Sub-group or VCA group is moved in
between other input strips it is then scrolled with them.
Effect Management
Add Effects on all Strips Selected
Select the Strips you wish to add the effect to.
Press and hold Ctrl + Shift keys.
From the right-click context menu select the required effect VS3 Effects > Add > xxx or VST Plug-In > Add > xxx
Remove Effects on all Strips selected
Select the Strips you wish to remove effects from.
Hover the Cursor over the Effects Slot you wish to clear.
Right-Click to open the context menu.VS3 Effects > Remove > xxx
Press and Hold the Ctrl + Shift keys.
Clicking on the Effect removes it from the Slot on all Strips selected.
To Next Page
Loading...