Machine Control : Transport Control Panel
23 - 576
Examples:
In the following examples there are three machines. At the top of each window is the host Pyramix Internal
Machine. Below this is a BETACAM - PVW-2800 and the third machine is a BiPhase transport or transports. (Via the
MTUsbSync Board) Both External Machines are controlled via the Sony 9-pin P2 protocol.
In the left-hand example the Host Pyramix is Master and both External Machines are in Chase and Locked.
In the right-hand example the Betacam is now the Master and both the Internal Pyramix and External BiPhase
Machines are in Chase and Locked.
Note: Machines NOT in chase can be used independently of the Master while the Master is in use
by using their individual controls. So you can locate on a machine whilst continuing to mix using
the Master and slaves.
Transport Control Examples
To Next Page
Loading...