Pyramix X - Automation in Editing and Libraries

Automation : Automation in Editing and Libraries
14 - 418
if the control only has two states (e.g. a button) or over a period of time if the control is a fader or knob. The time
period is determined by the value entered in the Release Time box in ms.
Preview Mode Options
The selections here affect actions in Automation Preview Mode.
Auto write on Stop Automation goes into Auto write mode when a Preview pass is stopped.
Confirm on Stop A confirmation dialog pops-up when a Preview pass is stopped.
Manual write Clicking on the Preview button writes the Preview pass.
Affect Parameters in :
Isolate When checked, parameters are affected in Isolate mode.
Read When checked, parameters are affected in Read mode.
Touch / Latch When checked, parameters are affected in Touch /Latch mode.
Write / Record When checked, parameters are affected in Write / Record mode.
Options
Check Source/Destination settings
When enabled (default) verifies the project when it is opened and ensures that the Automation > Automation
Tracks : Master Controls Link setting is set to Master Controls are linked to any Track.
Preview mode: Popup Snapshot window on Stop
When enabled pops-up the Filter Automation Tracks to Snapshot ... dialog.
Automation in Editing and Libraries
You can use the Automation menu Cut/Copy/Paste functions to copy data (even between projects). Just select a
Region and select Automation > Copy Selected Points, then choose which list(s) to copy, then go into another
project (or the same) and select Automation > Paste Points to Cursor or Paste Points to Original TC.
If you enable the menu item Edit > Enable Automation then any editing operation on Clips also applies to all
associated automation data (Cut/Copy/Paste, Auto-Ripple, etc…)
If you edit a Clip or Clips in the Timeline or drag a Clip or Clips to a library, all automation applied to the Clip(s) is
also copied/pasted according to the mode set in the same sub-menu.
E.g. Cut/Copy/Delete Displayed Automation.
When active Edit operations will only include Automation Curves visible in the Timeline.
Cut/Copy/Delete Whole Strip Automation when active (Enabled By Default) ALL Automation, even the curves
not visible currently in Timeline Track(s) will be affected when editing.
Note: Only parameters of controls present in both the source and destination Mixer strips will be
copied successfully.