Pyramix X - The Faders & Control Section; Parameters & Options Section

Fade Editor : The Faders & Control Section
9 - 202
Context Menu
Right-clicking in the graphical display pops-up a context menu:
The Fade In, Fade Out and X Fade sub-menus offer choices of Default (complete or Curve Only), Standard, (any
of the standard fade curves) and Load (from the list of previously saved presets)
The Faders & Control Section
Has the following controls and displays:
•The Fade Safe check box in the Fader section ensures (when checked) that all following fades to the right
of the one being edited are left intact while editing the current fade. This enables Auto-Ripple to be used
without Auto-Ripple while keeping Fade synchronization clean.
• When the Force Safe box is checked the Fade Editor forces Fade Safe to enabled after each edit change.
• Six Memory Set and six Memory Recall buttons store and recall all the settings in the Fade Editor. The
recall buttons are only numbered when there are stored parameters to recall.
• Gain Faders, Nudge buttons (in 0.5dB steps) and Manual Entry Value Box for both Fade Out & Fade In
• Intercept and Asymmetry Faders, Nudge buttons and Manual Entry Value Box (in dB)
• Length Faders, Nudge buttons and Manual Entry Value Box (in milliseconds. Type an s after any numeric
entry to obtain a value in seconds) for both Fade Out & In
• Length of Fade Out & In can be linked by clicking the Link button
• Length of Fade Out and In can be changed symmetrically (centered) by clicking the Mirror button.
• Position Faders, Nudge buttons and Manual Entry Value Box (in milliseconds, type an s after any number
entry for a value in seconds) for both Fade Out & In
• Position of Fade Out & In can be linked by clicking the Link button
• Media Position Faders, Nudge buttons and Manual Entry
• Value Box (in millisecond, type an s after any number entry for a value in seconds) for Fade In
Parameters & Options Section
In this table parameters and options may be modified by clicking on >.
There are these sections and fields:
Control
• Link Length (see above)
• Mirror Length (see above)
• Link Position (see above)
• Fade Safe (see above)
• Treat Gap as Fade. When set to Ye s enables two Clips which are not overlapping but with overlapping
Media to be edited in the Fade Editor as a fade. Default is No.
Display
• Shown Tracks offers these choices:
• All tracks