Mixer : Internal Return Buses
10 - 234
Internal Return Buses
Some of the time slots within MassCore can be reserved to convey Aux Send or Master Output Buses back to
input strips. In effect, these are internal send/return paths. To change the number of available Internal Return
Buses, close all open Projects (if any) and go to:
Settings > All Settings > Mixer > Mixer Settings.
The number of Internal Return Buses can be set using the Internal Buses combo box. Click on the OK button to
memorize the setting and exit.
The number of Internal Return Buses you assign here will be available as possible channel strip sources in the
mixer.
Note: Please be aware that a Mix Group Bus or Aux Group Bus will auto-take Internal Bus connec-
tion resources, starting from the last one. E.g. IB384-IB385 for the first two SubGroup Channels
added to a Mixer. This means that you will no longer see IB384 and IB385 in the IB list.
Note: A Strip fed from an Internal Return Bus will NOT be fully Delay Compensated when in
Auto-Monitoring mode and when in Repro mode the red ‘D’ will be appear to indicate that auto-
matic delay compensation will not be applied. On the other hand, recorded material will be
Compensated correctly and in sync with the current timeline events.
To Next Page
Loading...