Pyramix X - Multiple Strip Selection and Operations

Mixer : Highlighting
10 - 246
Multiple Strip Selection and Operations
Multiple Console Strips can be selected together.
Select Multiple Strips
Click on a Strip then press and hold the Ctrl key and click on the Strip number (below the fader) to add or remove
other strips to or from the selection.
Click on a Strip then press and hold Shift and click on another Strip number (below the fader) to select all Strips
between the first selected and the last.
To cancel the multiple selection click on a Strip number (below the fader) on any of the selected strips.
Linked Actions on Multiple Selected Strips
Press and hold [Ctrl] + [Shift] to perform any of the following on all selected (highlighted) strips:
• Double-click on any of the Faders, Gain Knobs or Pans in the selected strips to reset all of them to the
default value.
• Move Faders or Gain Knobs in any of the selected Strips moves all of the faders or knobs in the selected
strips while preserving their delta.
• Click on any button, e.g. On/Off, Mute, Solo, IP, Phase, Record Ready, etc… to set the same state on all the
selected strips.
• Add or subtract all selected Strips to or from a VCA group. (When subtracting the Leaving VCA Group
dialog appears for each Strip which is assigned to the VCA Group.)
• Adding Effects (Support for VS3 effects)
• Copying Effects (Support for VS3 effects)
•Stem change
Note: If [Shift] only is pressed and held the above actions are performed on ALL Strips regard-
less of any selections.
On a MultiBus Matrix router if [Control] + [Alt] are pressed and held then the patching is performed on
the selected Strips by incrementing the patched slot for each Strip.