Mixer : Buses
10 - 230
Object Bus Send
The Object Bus is a specialised type of General Mix Bus intended for use with formats such as Dolby Atmos which
use conventional “Bed” tracks along with Audio “Objects”.
An Object Bus Strip Send has an Object Router:
The Objects Router shows each Object Channel as a button. All Input Channels of the Strip shown in the box are
sent to the Object Channel(s) selected. (button(s) lit)
Note: When an Input Strip is routed to an Object bus, all other Buses for that strip input are
muted, as for a Solo.
• Objects Bus Routing is automated. Input sound can be sent for a limited time to any Objects Channel.
• Objects Buses can be Enabled and Disabled via the right-hand side [+] popup menu. This enables any
Object sending in the Object Bus to be disabled temporarily keeping all input audio in its Bed for editing
and monitoring.
To Next Page
Loading...