Menus : Edit
28 - 666
3 Gates Auto-Edit does Overwrite
When this option is checked (enabled), then when 2 Gates are set in a Source and 1
is set in the Destination then AutoEdit performs an Overwrite operation.
3 Gates Auto-Edit does Insert
When this option is checked (enabled), then when 2 Gates are set in a Source and 1
is set in the Destination then AutoEdit performs an Insert operation
Automation Unchanged for Source Track Groups
Automation Off for Source Track Groups
Automation Play for Source Track Groups
Note: For the above options: If the main Automation Mode is Write, then this mode is automatically changed to
Unchanged, Off or Play when a Source Track Group is selected, and changed back to Write when any other
Track Group is selected (typically the Destination one).
Note: When the following modes are enabled:
• Automation Off for Source Track Groups
• Automation Play for Source Track Groups
Then this also affects the Enable Cut/Copy/Paste Automation mode (set to Off for Source Tracks).
Automation Editing
Enable Automation Editing Enabled By Default. Enables Timeline Automation Editing. Mode is determined by
the next three entries:
Link to Media Content When enabled automation data is linked to the content so that if the Media Con-
tent is slipped the Automation data moves with it.
Cut/Copy/Delete Displayed Automation Will only affect Automation Curves visible in the Timeline when Editing
Cut/Copy/Delete Whole Strip Automation Enabled By Default. Will affect ALL Automation, even the curves not
visible currently in timeline Track(s) when editing.
Erase Points on Cut/Delete Erases all points contained within the selection. Does not add Automation points
to the selection boundaries.
Delete and Interpolate on Cut/Delete Enabled By Default. Interpolates a curve from the start of the selection to
end of the selection.
Delete and Maintain on Cut/Delete Does not interpolate the curve from start to end of the selection. Therefore
maintains a flat curve on Cut or Delete.
Jog-Wheel Editing>
A number of editing actions may be undertaken on a selected Clip or group
of Clips using a jog-wheel on an external hardware controller.
First select the Clip or group of Clips, then select the desired Jog-Wheel Editing
Mode from the choice of:
Move
Move And XFade
Lock XFade Trim
Force XFade Trim Lock
Force XFade Trim Unlock
Trim In
Trim Out
Trim Fade In
Trim Fade Out
Trim Fade In X (Symmetrically)
To Next Page
Loading...