Menus : Automation
28 - 693
Automation Snapshot Last Selection Applies the last Snapshot without the need to open the Filter automation Tracks to
Snapshot window. Ctrl + Click on the single Camera button does the same thing. I.e. the
last selection is applied directly thus improving the workflow.
Note: The the last entry is lost after a Mixer rebuild so, if a rebuild occurs between Snap-
shots the Filter automation Tracks to Snapshot Window will open.
Automation Snapshot Range Places automation key frames at the currently defined In / Out cursor positions, for all cur-
rently armed automation controls..
Automation Snapshot Range Last Selection Applies the last Snapshot Range without the need to open the Filter automa-
tion Tracks to Snapshot window. Ctrl + Click on the double Camera button does the
same thing. I.e. the last selection is applied directly thus improving the workflow.
Note: The the last entry is lost after a Mixer rebuild so, if a rebuild occurs between Snap-
shots the Filter automation Tracks to Snapshot Window will open.
Delete Selected Points & Interpolate Deletes all automation points contained in the selected Region and interpolates
between the last existing point before the selection and the first point after the selection.
Delete Selected Points Deletes all automation points contained in the selected Region.
Cut Selected Points Cuts all automation points contained in the selected Region
Copy Selected Points Copies all automation points contained in the selected Region
Paste Points to Cursor Pastes all copied or cut automation points at the cursor on the selected Track
Paste Points to Original TC Pastes all copied or cut automation points at the Original TimeCode on the selected Track
Bus Reassignment on Paste When set on the Automation Buses Reassignment dialog will appear if some auto-
mated bus elements of a strip are available in the automation clipboard. When set off the
dialog will appear only when at least one bus in the clipboard is not available in the tar-
get mixer.
Console Strips Mode - Touch The automation starts writing a new pass when the control is touched and stops writing
when the control is released.
Console Strips Mode - Latch The automation starts writing a new pass when the control is touched. The value when
the control is released will continue to be written until the transport stops.
Console Strips Mode - Trim Touch The automation starts updating the current pass when the control is touched and stops
updating when the control is released.
Console Strips Mode - Trim Latch The automation starts updating when the control is touched but continues when the
control is released and stops only when the transport stops.
Console Strips Mode - Record
Console Strips Mode - Read
Console Strips Mode - Isolate
Console Strips Release Mode - Release An interpolation is created from the current value to the value written in the previous
pass. I.e. a fade. The length of this is defined in Automation Settings > Auto-Release
Time.
Console Strips Release Mode - Snap A straight jump is made from the current control value to the value written in the previ-
ous pass.
Console Strips Release Mode - Write to Next The same value is kept after the last written point until the next point is found
in the previous pass.
Console Strips Release Mode - Write to End
Writes the current value to the end, ignoring previously written points. (If any).
Release Auto-Writing Immediately releases all controls currently recording automation.
Automation Tracks Opens the Automation Tracks window. This view allows the automation versions for a
specific control to be displayed. Once the desired control has been located in the tree
To Next Page
Loading...