Media Management & Libraries : Media Management Tab Window
4 - 75
Settings
Time Stretch
Four options are available:
% (percentage) Type in the field to enter a percentage value between 50 and 200.
24 to 25fps As it says.
25 to 24fps As it says.
Transcribe mode (2x Stretch) As it says.
Quality & Localization
Three quality modes are available in the drop-down list: Good, Better, Best.
Time/Frequency localization:
The slider can be set to one of five positions from far left to far right:
1. Far left. Selects full time localization. Good setting for single instruments and voice.
2. Time/frequency localization with emphasis on time localization. If setting 1. produces echoes this give better
results.
3. Middle. This sets the time/frequency localization halfway between time and frequency domains. It is the best
setting for all general purpose signals and should be set as default for non-preview processing.
4. Higher frequency localization and less time localization. May be a better choice for classical music than the
lower Time/Freq localization settings.
5. far right. Highest frequency localization. This may not be an ideal choice if you're dealing with signals with
very fast attack transients.
Pitch
The sliders enable values of -12 to +12 semitones and -50 to +50 cents to be set.
Formants
Choice of Preserve, which results in the most natural pitch shifting or manual with values of 0.5 - 2.0 available.
Samplerate Conversion
Where the sampling rate of a Media File is different to the current Project, Pyramix offers a simple means of con-
verting the Media File’s sample rate at very high quality. Using the Merging Technologies HeptaCon Sample Rate
Converter:
Radio buttons offer the choice of two text entry fields, New name for the file or Add Suffix to the existing file-
name. A check box selects Keep Original File Format otherwise the file will be converted to PMF format as well
as sample rate converted.
MT Hepta SRC module dialog
To Next Page
Loading...