Settings : Application
29 - 753
Auto-Release Options
Release time If Auto Release is enabled any control will, when released or when the transport is
stopped, return to its value or state in the previous automation pass or the default
where no previous pass exists. This occurs either immediately if the control only
has two states (e.g. a button) or over a period of time if the control is a fader or
knob. The time period is determined by the value entered in the Release Time box
in ms.
Preview Mode Options
The selections here affect actions in Automation Preview Mode.
Auto write on Stop Automation goes into Auto write mode when a Preview pass is stopped.
Confirm on Stop A confirmation dialog pops-up when a Preview pass is stopped.
Manual write Clicking on the Preview button writes the Preview pass.
Affect Parameters in :
Isolate When checked, parameters are affected in Isolate mode.
Read When checked, parameters are affected in Read mode.
Touch / Latch When checked, parameters are affected in Touch /Latch mode.
Write / Record When checked, parameters are affected in Write / Record mode.
Options
Check Source/Destination settings When enabled (default) verifies the project when it is opened and ensures
that the Automation > Automation Tracks : Master Controls Link setting is set
to Master Controls are linked to any Track.
Write Next/End only if the Control is touched on Stop. Otherwise it Auto-releases
To Next Page
Loading...