202 Configuring the Library
4 The Datapath Conditioning dialog box appears, showing all the I/O blades found in the library. Each
blade is identified by name and by geographic location.
5 Click a blade to highlight it and then click Configure.
The Datapath Conditioning Setting dialog box appears.
6 In the Level area, choose the appropriate level. The default level is Interface Test. To enable data path
monitoring tickets, set the level to Device Datapath Test.
The following table describes the functionality for each data path monitoring level.
7 In the Enter new Interval text box, type the amount of time that should elapse between automatic
monitoring checks. The interval can range from 1 to 2,880 minutes (48 hours). The default interval is 60
minutes.
Level Name Functionality Description
Interface Test
Performs tests to verify that Fibre Channel controllers on I/O blade are
responsive to commands.
Device
Datapath Test
Everything from Interface Test level, in addition to performing a device inquiry on
each target device.
To Next Page
Loading...
