236 Adding Optional Hardware
You might need to remove more than one magazine to create enough space for the drive you are
adding. It is recommended that you remove all of the magazines in the column and remove them from
the top down.
12 Use a 2.5 mm hex wrench to unscrew the retaining screws (two screws per plate) and remove the cover
plates from the drive position.
13 Reinstall the magazines above the new drive position.
Make sure that you fully seat each magazine by inserting each of the
magazine’s four corner tabs into the available holes in the cover plate.
cover plates
two 2.5 mm hex screws
To Next Page
Loading...
