Radwin 2000+ SERIES - Page 122

RADWIN2000+SeriesUserManual Release4.2.40 7‐9
Management
3. ForSecuritymodelyoumaychoosebetweenSNMPv1orSNMPv3.Thechoiceissite
dependent.IfyouchooseSNMPv1,youmayonlyenteranIPaddressandport
number.ForSNMPv3,youshouldsupplyausernameandpassword:
4. ClickOKtosaveyourchoice.
Notethatforeachactivetrapdestination,theClearTrapDestinationbuttonisenabled:
VLANforManagement
ManagementVLANConfiguration
Figure7‐4:VLANforManagement
VLANManagementenablesseparationofusertrafficfrommanagementtrafficwhenever
suchseparationisrequired.Itisrecommendedthateachmemberofasectorbeconfigured
withdifferentVLANIDsformanagementtraffic.(Thisreducesyourchancesofaccidentally
lockingyourselfoutofthelink.)
 ToenableVLANformanagement:
1. InthewindowofFigure 7‐4,checktheEnabledbox.
2. EnteraVLANID.Itsvalueshouldbebetween2and4094.
AfterenteringtheVLANID,onlypacketswiththespecifiedVLANIDareprocessed
formanagementpurposesbytheradiounit.Thisincludesallthepr
otocolssup‐
VLANIDsareusedbyRADWINproductsinthreeseparatecontexts:
ManagementVLAN,TrafficVLANandEthernetRing.Itisrecommended
thatyouusedifferentVLANIDsforeachcontext.