DRUM SECTION
C262/C265 3-62 SM
NOTE:
1) To remove the drum clamper screw on the operation side, turn the
drum into the position shown in the first diagram and pull out the
lever [B]. To rotate the drum, release the stopper [C] on the rear of
the drum.
2) When replacing the drum clamper, install the spring on the opposite
side as shown in the illustration.
3) Do not put the drum unit upside down. However, if you must put it
upside down, wipe off the ink around the ink roller first (use SP2-
002-1, select OFF, and feed paper until ink ends). After you
complete your work on the machine, make sure to return SP2-2-1 to
its default (ink detection ON).
[D]: Metal screen ( x 12)
C262R060.WMF
[D]
To Next Page
Loading...
