DRUM SECTION
SM 3-63 C262/C265
Replacement
Adjustment
CAUTION:
1) Do not scratch the cloth screen or metal screen.
2) Make sure that the correct end of the metal screen is overlapping.
(Refer to the lower right part of the upper illustration.)
3) When attaching the metal screen to the drum flanges, wrap it so that
the gap is correct. (Refer to the upper part of the upper illustration.)
4) When installing the master clamper [E], make sure that it is the
correct way around. The side with the sandpaper [F] must be facing
the black patch [G].
5) Do not allow the inside of the master clamper to become dirty with
ink. If it is dirty with ink, the master may slip off and the image
position on the prints will move toward the trailing edge of the print
during a printing run.
6) Use a cloth dampened with water to clean the inside of the master
clamper. Do not use alcohol or other solvents. The clamping force of
the magnet will be weakened.
C262R061.WMF
C262R062.WMF
0 to 0.3mm
0 to 0.3mm
The standard position
for the screen (the left
side overlaps, as
viewed from the
operation panel).
Operation Side
[E]
[F][G]
To Next Page
Loading...
