PRINTING SECTION
SM 3-103 C262/C265
Replacement
Adjustment
4. Pull it a little toward you (to disengage the join behind the cylinder). Then, push
up to the drum position.
CAUTION: There is an encoder plate at the rear of the pressure cylinder. Be
careful not to damage it when removing the pressure cylinder.
5. Pull the pressure cylinder toward you, and put it on the flat area of the inner
cover [G].
6. With the left hand, hold the bearing tightly, putting fingers into the holes as
shown.
7. Support the rear of the pressure cylinder with the right hand. Then, bring out
the cylinder using both hands.
C262R109.WMF
[G]
To Next Page
Loading...
