MAIN DRIVE AND IMAGE UP/DOWN SHIFTING DRIVE SECTION
C262/C265 3-120 SM
12. Adjust the exit pawl drive timing. ( 3.12.6 Paper exit pawl drive timing
adjustment.)
13. Remove the indicator disk bracket [Q] and the timing belt [R] ( x 2).
14. Install the indicator disk bracket [Q] and the timing belt [R] when the line and
arrow on the indicator disk [S] are in line ( x 2), and the actuator is in the
sensor, as shown in the diagram.
15. Install the wire protection cover [T] ( x 2).
16. Install the main motor control board [U] ( x 3, x 4).
C262R198.WMF
C262R143.WMF
[U]
[T]
[Q]
[R]
[S]
To Next Page
Loading...
