MAIN DRIVE AND IMAGE UP/DOWN SHIFTING DRIVE SECTION
SM 3-131 C262/C265
Replacement
Adjustment
7. While aligning and holding the pressure cylinder horizontally as shown, set the
main drive unit so that the convex points of the pressure cylinder’s drive disk
[E] meet the concave points of the pressure cylinder drive transmission disk [F]
(made of white plastic).
NOTE: Hold the drum drive disk, image shifting arm, pressure cylinder drive
disk, and scissors gear in their home positions as explained in steps 1,
2 and 3.
8. Secure the main drive unit [G] on the machine rear frame ( x 6).
C262R133.WMF
C262R134.WMF
[E]
[F]
[G]
To Next Page
Loading...
