MAIN DRIVE AND IMAGE UP/DOWN SHIFTING DRIVE SECTION
SM 3-133 C262/C265
Replacement
Adjustment
Fine adjustment using the special tools
• Left cover ( 3.2.2)
• Paper delivery cover ( 3.12.2)
• Air knife fan unit ( 3.12.2)
• Paper exit pawl ( 3.12.1)
13. Install the drum unit in the machine.
14. Install the front cover.
15. Close the front cover, connect the power plug, then turn on the main switch.
The up/down image shifting mechanism will initialize.
NOTE: This procedure is needed to return the image shift arm to its home
position. If the image shift arm is not returned to home position exactly
in this step, correct positioning for each main drive part will not be
obtained.
16. Turn off the main switch, and disconnect the power plug.
• Knob ( 3.2.1)
• Paper delivery unit ( 3.12.2)
• Printing pressure shift cam unit ( 3.12.3)
17. Make sure that the drum drive disk is in the home position, by installing the
drum drive securing tool [A].
NOTE:
1) The tools are available as a service part. The part number is
#C2299000 (three parts as set).
2) If the special tool is not available, align the elongated hole in the
drum drive disk [B] with the shaft [C] below it, as shown.
C262R136.WMF
[A]
[B]
[C]
To Next Page
Loading...
