MAIN DRIVE AND IMAGE UP/DOWN SHIFTING DRIVE SECTION
C262/C265 3-136 SM
the main drive will turn slightly when the two shafts (special tools) are
removed. If you turned it in the wrong order, return to step 20 then do
step 21.
22. Set the drum drive-securing tool once again. (See step 17.)
CAUTION: Do not turn the drum drive disk by force while setting the tool. If you
turned the disk, return to step 20 then do step 21.
23. Secure the pressure cylinder drive gear [J] ( x 2).
24. Install the printing pressure cam drive gear and firmly tighten the 2 screws [K].
NOTE:
1) To remove gear play, secure the cam drive gear while turning it
counterclockwise (as viewed from the rear).
2) Secure the cam drive gear by tightening the two screws in the
middle of the curved oval holes. This allows for the maximum
adjustable range for later repositioning of the gear.
C262R141.WMF
[J]
[K]
To Next Page
Loading...
