SERVICE PROGRAM MODE
C262/C265 5-24 SM
11: 2-6-14 (Thermal Head Writing Mode)
If this is set to ‘ON’, the thermal head writing position is moved a small amount
between masters. The amount is set with SP2-6-15 (Thermal Head Writing Position
Shift Amount) automatically. This changes the side-to-side margin on the master.
This prevents the same parts of the thermal head from being used all the time,
because if masters that contain the same image (such as a logo) are made
frequently, this can burn out the thermal head.
Default: OFF
2-6-15 (Thermal Head Swinging Quantity)
Settings: 1 to 5 mm
Default: 2 mm
12: 2-6-16 (Constance Print Pressure Mode)
The print pressure is fixed to the value of SP2-6-17 (Print Pressure In Fixing Mode).
Otherwise, the print pressure will be changed by the print speed and the
temperature.
Default: OFF (pressure is changed by print speed and temperature)
2-6-17 (Print Pressure In Fixing Mode)
Settings: 0 to 6
Default: 3
13: 2-6-18 (Print Pressure Shift Adjust)
The same amount of print pressure is added to all the print pressure settings (SP
6-54 to 6-58).
NOTE: The maximum pressure is 6, and the minimum pressure is 0. If you
input a value that takes the pressure outside this range, it is ignored,
and either 6 or 0 will be used.
Settings: -2 to +2
Default: 0
14: 2-6-20 (135rpm Limit)
Paper longer than B4 SEF can cause a paper exit jam. Because of this, the
machine cannot use the 6
th
speed print for paper that is longer than B4SEF.
If this SP is set to ‘off’, this limitation will be ignored.
CAUTION: When this setting is ‘off’, a paper exit jam could occur for paper larger
than B4SEF after printing out about 600 sheets. Stop the print job when
there are about 600 sheets of paper on the paper delivery table.
To Next Page
Loading...
