INSTALLATION PROCEDURE
SM 1-27 C262/C265
Installation
3) Then, with SP 2-10-1 to -4, you can specify the meaning of each of these 4
ID codes.
• 2-10-1 specifies the meaning of ID0
• 2-10-2 specifies the meaning of ID1
• 2-10-3 specifies the meaning of ID2
• 2-10-4 specifies the meaning of ID3
There are 15 possible colors that can be specified with SP 2-10-1 to -4.
Allocation of color codes
0 1 2 3 4 5 6 7
Other Red Blue Green Brown Gray Yellow Purple
8 9 10 11 12 13 14
Maroon Navy Orange Teal
Red
Base
Blue
Base
Yellow
Base
Default: 0 (other)
For example, you install a drum with DPS 902-1 and -2 both set to OFF (this
means ‘ID0’). If this drum contains blue ink, then set SP 2-10-1 to 2 (blue).
Then ‘blue’ will be shown on the display panel when this drum is installed.
The names in the above table are fixed in the software. So, for example, if
the drum contains gold-coloured ink, the selected color should be 14 (yellow
base).
11. Place the original on the exposure glass or ADF.
12. Make a master and make 30 prints with this master. Do this at least three times,
until the image quality is acceptable.
NOTE: This is a new drum. Because of this, before the first print is made, ink is
supplied automatically. This takes 2 minutes.
To Next Page
Loading...
