INSTALLATION PROCEDURE
C262/C265 1-26 SM
10. Make sure that SP 2-10-1~4 and DPS902 [A] have the correct settings for the
color of ink that is used.
1) First, set the dip switch 901 (for drum-type detection) on the ink detection
board [B] to ‘color drum’. To do this, DIPSW 901-1 must be off and 901-2
must be on.
2) Then, set the DPS902 dip switches [A] on the drum to specify the ID of the
color.
Four color IDs can be recognized.
DPS902 -1 -2
ID0 OFF OFF
ID1 ON OFF
ID2 OFF ON
ID3 ON ON
ON
OFF
C262I901.WMFF
ON
OFF
C262I902.WMFF
[A]
[B]
To Next Page
Loading...
