Rohde & Schwarz FSVA - Page 957

Remote Control
R&S
®
FSVA/FSV
957Operating Manual 1176.7510.02 ─ 09
STATus:OPERation[:EVENt]...........................................................................................957
STATus:OPERation:CONDition....................................................................................... 957
STATus:OPERation:ENABle........................................................................................... 957
STATus:OPERation:PTRansition.....................................................................................957
STATus:OPERation:NTRansition.....................................................................................958
STATus:PRESet............................................................................................................ 958
STATus:QUEStionable:CONDition...................................................................................958
STATus:QUEStionable[:EVENt]?.....................................................................................959
STATus:QUEStionable:ENABle.......................................................................................959
STATus:QUEStionable:PTRansition.................................................................................959
STATus:QUEStionable:NTRansition................................................................................ 959
STATus:QUEue[:NEXT?]?.............................................................................................. 960
STATus:OPERation[:EVENt]
This command queries the contents of the EVENt part of the STATus:OPERation reg-
ister. The contents of the EVENt part are deleted after readout.
Example:
STAT:OPER?
Mode: all
STATus:OPERation:CONDition
This command queries the CONDition part of the STATus:OPERation register (see
the base unit description of status registers in the Remote Control Basics chapter).
Readout does not delete the contents of the CONDition part. The value returned
reflects the current hardware status.
Example:
STAT:OPER:COND?
Mode: all
STATus:OPERation:ENABle
This command sets the bits of the ENABle section of the STATus:OPERation register.
The ENABle register selectively enables the individual events of the associated EVENt
section for the summary bit in the status byte.
Parameters:
0 to 65535
Example:
STAT:OPER:ENAB 65535
Usage: SCPI confirmed
Mode: all
STATus:OPERation:PTRansition
This command sets the edge detectors of all bits of the STATus:OPERation register
from 0 to 1 for the transitions of the CONDition bit.
Remote Control – Commands