Rohde & Schwarz FSVA - Page 958

Remote Control
R&S
®
FSVA/FSV
958Operating Manual 1176.7510.02 ─ 09
Parameters:
0 to 65535
Example:
STAT:OPER:PTR 65535
Usage: SCPI confirmed
Mode: all
STATus:OPERation:NTRansition
This command sets the edge detectors of all bits of the STATus:OPERation register
from 1 to 0 for the transitions of the CONDition bit.
Parameters:
0 to 65535
Example:
STAT:OPER:NTR 65535
Usage: SCPI confirmed
Mode: all
STATus:PRESet
This command resets the edge detectors and ENABle parts of all registers to a defined
value. All PTRansition parts are set to FFFFh, i.e. all transitions from 0 to 1 are detec-
ted. All NTRansition parts are set to 0, i.e. a transition from 1 to 0 in a CONDition bit is
not detected. The ENABle part of the STATus:OPERation and STATus:QUEStionable
registers are set to 0, i.e. all events in these registers are not passed on.
Example:
STAT:PRES
Usage: SCPI confirmed
Mode: all
STATus:QUEStionable:CONDition
This command queries the CONDition part of the "STATus:QUEStionable" register.
This part contains the sum bit of the next lower register. This register part can only be
read, but not written into or cleared. Readout does not delete the contents of the CON-
Dition part.
Example:
STAT:QUES:COND?
Mode: all
Remote Control – Commands