Detailed description
2.1 Axis monitoring
Basic logic functions: Axis monitoring, protection zones (A3)
36 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Effects
Automatic operating modes
• With / without transformation
The part program block with a programmed traversing motion that would lead to
overrunning of the working area limitation is not started.
• With overlaid motion
The axis, which would violate the working area limitation due to the overlaid movement, is
braked without jerk limitation and will come to the position of the working area limitation.
Other axes involved in the movement are braked corresponding to the currently
applicable acceleration. The preset path is left during this process.
Manual operating modes
• JOG with / without transformation
The axis is positioned at the working area limitation and then stopped.
General
• Activation of the working area limitation
If the actual position of an axis after activation is located ouutside of the working area
limitation, it is stopped with the maximum permissible acceleration without jerk limitation.
• Overrunning of the working area limitation in JOG mode
If the position of the working area limitation is reached and renewed pressing of the
traversing button should cause further travel in this direction, an alarm is displayed and
the axis is not moved farther.
• Geo-axis replacement
Through the following machine data it is adjustable, whether during geometry axis
change the active working area limitation is retained or deactivated:
MD10604 $MN_WALIM_GEOAX_CHANGE_MODE
= 0: The working area limitation is deactivated during the geometry axis change.
= 1: The working area limitation remains activated during the geometry axis change.
To Next Page
Loading...
Need help?
General
