Functions
2.16 Excessive jerk for block transitions without constant curvature (axis-specific)
Basic logic functions: Acceleration (B2)
38 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
2.15.3 Programming
Programmability
The function is not programmable.
2.16 Excessive jerk for block transitions without constant curvature (axis-
specific)
2.16.1 Detailed Description
2.16.1.1 General Information
Overview
In the case of block transitions without constant curvature (e.g. straight line > circle), the
programmable controller has to decelerate movement of the geometry axes significantly in
order to ensure compliance with the parameterized axis dynamics. For the purpose of
reducing/avoiding deceleration in connection with block transitions without constant
curvature, a higher level of axis-specific jerk can be enabled.
The excessive jerk is parameterized using a dedicated axis-specific maximum value.
2.16.2 Activation
2.16.2.1 Parameterization
Function
The excessive jerk for block transitions without constant curvature is parameterized using
the axis-specific machine data:
MD32432 $MA_PATH_TRANS_JERK_LIM
(excessive jerk for block transitions without constant curvature)
To Next Page
Loading...
Need help?
General
