Detailed description
2.4 Frames
Basic logic functions: Axes, coordinate systems, frames (K2)
134 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
2.4.12.5 Block search
Block search
Data management frames are also modified when carrying out a block search with
calculation.
Cancellation of block search
If the block search is aborted with RESET, then the machine data:
MD28560 $MC_MM_SEARCH_RUN_RESTORE_MODE
can be used to configure that all data management frames are set to the value they had
before the block search:
Bit Significance
0 All frames in the data management are restored.
In case of cascaded block searches, the frames are set to the status of the previous block
search.
SERUPRO
The "SERUPRO" function is not supported.
2.4.12.6 REPOS
There is no special treatment for frames. If a frame is modified in an ASUB, it is retained in
the program. On repositioning with REPOS, a modified frame is included, provided the
modification was activated in the ASUB.
To Next Page
Loading...
Need help?
General
