Basic logic functions: Transverse axes (P1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
21
Index
A
assigning the reference axis via SCC[AX] for
G96/G961/G962, 8
C
channel-specific basic position after power up,
RESET, 8
Channel-specific diameter programming, 9
Constant cutting rate, 7
D
DIACYCOFA[axis], 10
DIAM90, 9
DIAM90/DIAM90A[AX], 11
DIAM90A[axis], 10
DIAMCHAN, 10
DIAMCHANA[axis], 10
DIAMCYCOF, 9
DIAMCYCOF/DIACYCOFA[AX], 11
DIAMOF, 9
DIAMOFA[axis], 10
DIAMON, 9
DIAMON/DIAMONA[AX], 11
DIAMONA[axis], 10
Display of actual values as a diameter, 13
Display of remaining path in WCS always as a
radius, 12
Displaying position values in the diameter, 12
DRF-traveling with handwheel, 12
G
Geometry axes during handwheel traveling, 13
M
MD20100, 7, 13
MD20110, 8, 10
MD20112, 8
MD20150, 8, 10
MD20152, 8, 10
MD27100, 12
MD30460, 7, 9, 10, 13
P
PLC axes, 12
Position of the transverse axis in the machine
coordinate system, 7
R
Radius-related data, 11
Reference axis for RESET, end of parts program or
start of parts program retained, 8
S
Several transverse axes
Acceptance of the additional transverse axis, 10
Axis identifier, 5
Axis replacement in synchronized actions, 10
Axis replacement via axis container rotation, 10
Axis-specific diameter programming, 9
Definition of several transversing axes in the
channel, 7
Dimension can be activated as a diameter, 13
T
Transverse axes functions, 5
Transverse axis
Definition, 5
Definition of a transversing axis in the channel, 7
Dimensions, 9
Initial setting, 10
Position and designation, 7
Programming the transversing commands, 6
W
Work offset $P_EXTFRAME, 13
To Next Page
Loading...
Need help?
General
