EasyManuals Logo

Siemens MCP 398C Function Manual

Siemens MCP 398C
2184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1592 background imageLoading...
Page #1592 background image
Detailed description
2.6 Referencing with absolute value encoders
Basic logic functions: Reference Point Approach (R1)
46 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
The limiting frequency corresponding to the limiting speed is calculated to be:
0'
0'
0'0'
MD31020 $MA_ENC_RESOL (Encoder lines per revolution)
MD10050 $MN_SYSCLOCK_CYCLE_TIME (System clock cycle)
MD10070 $MN_IPO_SYSCLOCK_TIME_RATIO (Factor for interpolator cycle)
Note
The position control switching speed relevant for spindles is set according to the encoder
limiting frequency of the absolute value encoder of the spindle:
MD35300 $MA_SPIND_POSCTRL_VELO (position control switching speed)
MD36300 $MA_ENC_FREQ_LIMIT (Encoder limit frequency)
2.6.9 Referencing variants that are not supported
The following referencing variants are not supported when used with absolute encoders:
Referencing / calibrating with encoder zero mark
Distancecoded reference marks
BERO with two-edge evaluation

Table of Contents

Other manuals for Siemens MCP 398C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens MCP 398C and is the answer not in the manual?

Siemens MCP 398C Specifications

General IconGeneral
BrandSiemens
ModelMCP 398C
CategoryControl Systems
LanguageEnglish

Related product manuals