Detailed description
2.7 Program operation mode
Basic logic functions: Mode group, channel, program operation, reset response (K1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
107
2.7.8 Part-Program Start
Start handling
Table 2-5 Typical program sequence
Sequence Command Conditions
(must be satisfied before the
command)
Comments
1 Load program (via the operator
interface or part program)
2 Select AUTOMATIC mode
3 Program preselection Channel preselected
Preselected channel in
RESET state
User ID sufficient for
program preselection
4 NC start for preselected channel NC start disable not
available
Reference point approached in
all
axes
5 Program execution
6 M02/M30/RESET None End of program
To Next Page
Loading...
Need help?
General
