Basic logic functions: Axis monitoring, protection zones (A3)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
79
Data lists
5
5.1 Machine data
5.1.1 NC-specific machine data
Axis monitoring
Number Identifier: $MN_ Description
10604 WALIM_GEOAX_CHANGE_MODE Working area limitation during switchover of geometry
axes
10710 PROG_SD_RESET_SAVE_TAB Setting data to be updated
Protection zones
Number Identifier: $MN_ Description
10618 PROTAREA_GEOAX_CHANGE_MODE Protection zone for switchover of geo axes
18190 MM_NUM_PROTECT_AREA_NCK Number of files for machinerelated protection zones
5.1.2 Channelspecific machine data
Axis monitoring
Number Identifier: $MC_ Description
20150 GCODE_RESET_VALUES[n] Reset G groups
21020 WORKAREA_WITH_TOOL_RADIUS Allowance for tool radius with working area limitation
24130 TRAFO_INCLUDES_TOOL_1 Tool handling with active transformation 1.
24230 TRAFO_INCLUDES_TOOL_2 Tool handling with active transformation 2.
24330 TRAFO_INCLUDES_TOOL_3 Tool handling with active transformation 3.
24426 TRAFO_INCLUDES_TOOL_4 Tool handling with active transformation 4.
To Next Page
Loading...
Need help?
General
