Detailed description
2.3 Starting up hardware configuration of PLC CPUs
Basic logic functions: PLC basic program solution line (P3 sl)
14 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
2.3 Starting up hardware configuration of PLC CPUs
General procedure
The hardware configuration for the PLC CPUs used in the NCU7x0, including other
components of the NCU (NCK, CP, HMI, drive), must be defined via STEP 7. Proceed as
follows in STEP7:
1. Create a new project (File, New, Project)
2. Insert, Hardware, SIMATIC 300 station
3. Select the SIMATIC 300 station with the mouse
4. right mouse button, open object
The HW-Config is now started
5. An appropriate SINUMERIK component is selected from the hardware catalog
"SIMATIC 300 \ SINUMERIK \ 840D sl".
6. I/Os are to be extended from the hardware catalog of STEP 7
The addresses for the I/O modules can be changed, if needed.
Prerequisites
In order to be able to select SINUMERIK components from the hardware catalog, you must
run the Toolbox setup program first ("Hardware expansions for STEP7" and "Starter"). The
current version of the hardware expansion for STEP7 can also be found under eSupport.
Example of current hadrware allocations PLC to NCU
Table 2-1 Hardware expansions
NCU
MLFB
Comparable
SIMATIC CPU MLFB
included
Selection from STEP7 hardware
catalog
SINUMERIK 840D NCU
710.1
6FC5 371-0AA00-0AA0 6ES7 317-2AJ00-0AB0 NCU710.1
STEP 7 V5.3 SP2 and higher
and Toolbox 840D sl 01.01.00)
SINUMERIK 840D NCU
720.1
6FC5 372-0AA00-0AA0 6ES7 317-2AJ00-0AB0 NCU720.1
STEP 7 V5.3 SP2 and higher
and Toolbox 840D sl 01.01.00)
SINUMERIK 840D NCU
730.1
6FC5 373-0AA00-0AA0 6ES7 317-2AJ00-0AB0 NCU730.1
STEP 7 V5.3 SP2 and higher
and Toolbox 840D sl 01.01.00)
SINUMERIK 840Di sl with
MCI2
6FC5 222-0AA02-1AA0 6ES7 317-2AJ00-0AB0 840Di with PLC317-2 DP
STEP 7 V5.3 SP2 and higher
and Toolbox 840D sl 01.02.00)
To Next Page
Loading...
Need help?
General
