EasyManuals Logo

Siemens MCP 398C Function Manual

Siemens MCP 398C
2184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #243 background imageLoading...
Page #243 background image
Functions
2.9 Excessive acceleration for non-tangential block transitions (axis-specific)
Basic logic functions: Acceleration (B2)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
25
2.9 Excessive acceleration for non-tangential block transitions (axis-
specific)
2.9.1 Detailed Description
2.9.1.1 General Information
Function
In the case of non-tangential block transitions (corners), the programmable controller may
have to decelerate the geometry axes significantly in order to ensure compliance with the
parameterized axis dynamics. For the purpose of reducing/avoiding deceleration in
connection with non-tangential block transitions, a higher level of axis-specific acceleration
can be enabled.
Excessive acceleration is parameterized using a factor calculated in relation to the axis-
specific maximum value. This is used to generate the maximum value for axis-specific
acceleration with non-tangential block transitions that is taken into account by the path
planning component during preprocessing:
Acceleration[axis] =
MD32300 $MA_MAX_AX_ACCEL * MD32310 $MA_MAX_ACCEL_OVL_FACTOR
2.9.2 Activation
2.9.2.1 Parameterization
Function
Excessive acceleration for non-tangential block transitions is parameterized using the axis-
specific machine data:
MD32310 $MA_MAX_ACCEL_OVL_FACTOR
(overload factor for velocity jumps)
2.9.3 Programming
Programmability
The function is not programmable.

Table of Contents

Other manuals for Siemens MCP 398C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens MCP 398C and is the answer not in the manual?

Siemens MCP 398C Specifications

General IconGeneral
BrandSiemens
ModelMCP 398C
CategoryControl Systems
LanguageEnglish

Related product manuals