Basic logic functions: Axis monitoring, protection zones (A3)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
85
Index
$
$AC_WORKAREA_CS_COORD_SYSTEM, 38
$AC_WORKAREA_CS_LIMIT_MINUS, 38
$AC_WORKAREA_CS_LIMIT_PLUS, 38
$AC_WORKAREA_CS_MINUS_ENABLE, 38
$AC_WORKAREA_CS_PLUS_ENABLE, 38
A
Activation of protection zones
Example, 74
Axis clamping
Operations, optimized, 13
Axis monitoring, 5
Axis monitoring functions
Actual velocity, 21
Axis/spindlespecific setting data, 77
Constraints, 61
Following error, 8
Speed setpoint, 19
Zero speed, 11
C
Contour error, 7
Coordinate system, 41
D
DB 31, ...
DBX1.4, 13, 19
DBX1.5, 21, 22
DBX1.6, 21, 22
DBX12.0, 30
DBX12.1, 30
DBX12.2, 31
DBX12.3, 31
DBX2.2, 13, 14
DBX2.3, 13, 19
DBX39.0, 53, 55, 56
DBX60.2, 22
DBX60.3, 22
DBX60.4, 29
DBX60.5, 29
DBX60.6, 11, 19
DBX60.7, 11, 19
DBX64.6, 11
DBX64.7, 11
DB21, ...
DBX10.0 to DBX11.1, 52
DBX272.0 to 273.1, 52
DBX274.0 to 275.1, 52
DBX276.0 to DBX277.1, 52
DBX278.0 to DBX279.1, 52
DBX8.0 to DBX9.1, 52
Dirt deposits, 28
E
Encoder monitoring functions, 22
Encoder frequency, 22
Encoder type, 23
Zero marks, 23, 24
G
G25, 35
G26, 35
H
Hardware faults, 28
Hardware limit switches, 30
I
Interface signals|Table, 78
L
Limit switches-monitoring, 29
Linear signal distortions, 7
To Next Page
Loading...
Need help?
General
