Detailed Description
2.3 Configurable gear adaptation
Basic logic functions: Spindles (S1)
54 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Oscillation via PLC
NC/PLC IS:
DB31, ... DBX18.4 (Oscillation via PLC)
and
DB31, ... DBX18.5 (oscillation speed)
accelerates the spindle motor to the speed (with oscillation acceleration) defined in machine
data:
MD35400 $MA_SPIND_OSCILL_DES_VELO (oscillation speed)
.
The direction of rotation is defined by NC/PLC IS:
DB31, ... DBX18.7 (Set direction of rotation CCW)
and
DB31, ... DBX18.6 (Set direction of rotation CW)
.
The oscillation movement and the two times t1 and t2 (for clockwise and counterclockwise
rotation) must be simulated on the PLC.
Special points to be noted
Setting/Resetting the NC/PLC IS and machine data in oscillation mode:
• To decelerate the spindle, the PLC user need not set NC/PLC IS:
DB31, ... DBX4.3 (Spindle stop).
The spindle is brought to a standstill internally by the control when a gear step change is
requested.
• The gear step change should always be terminated with NC/PLC IS:
DB31, ... DBX16.3 (Gear changed)
.
• NC/PLC IS:
DB31, ... DBX18.5 (Oscillation speed)
should be used to support mechanical engagement of the gear.
It has no effect on the internal control mechanism for the gear step change procedure
and should therefore only be set as necessary.
• If NC/PLC IS:
DB31, ... DBX18.5 (Oscillation speed)
is reset, oscillation mode stops.
However, the spindle remains in "oscillation mode".
• The acceleration is defined in the following machine data:
MD35410 $MA_SPIND_OSCILL_ACCEL
• The spindle will cease to be synchronized if an indirect measuring system (motor
encoder) is used.
If the machine data is set to:
MD31050 $MA_ENC_IS_DIRECT = 0,
NC/PLC IS:
DB31, ... DBX60.4/5 = 0 (Homed/Synchronized)
is automatically deleted.
The zero mark is synchronized the next time it is crossed.
To Next Page
Loading...
Need help?
General
