EasyManuals Logo

Siemens MCP 398C Function Manual

Siemens MCP 398C
2184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1669 background imageLoading...
Page #1669 background image
Detailed Description
2.3 Configurable gear adaptation
Basic logic functions: Spindles (S1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
59
Position control is not disabled when an active measuring system with indirect encoder
(motor encoder) is used:
MD31040 $MA_ENC_IS_DIRECT = 0
If a measuring system with a direct encoder (load encoder) is active, position control is
deactivated:
DB31, ... DBX61.5 = 0,
because the induction flux to the load is interrupted and closed-loop position control is no
longer possible.
If positioncontrolled operation is not possible, it can be disabled by
resetting "Servo enable":
DB31, ... DBX2.1 = 0
.
Mechanical switchover of the gear step on the machine.
No oscillation motion is required from the drive.
NC/PLC IS:
DB31, ... DBX18.5 (Oscillation enable)
and
DB31, ... DBX18.4 (Oscillation via PLC)
should not be set.
In principle, oscillation movement is still possible at this point.
Writing of NC/PLC IS:
DB31, ... DBX16.0-16.2 (Actual gear step A to C)
by the PLC.
After signal:
DB31, ... DBX16.3 (Gear step changed),
the last movement to be active is continued, if available.
For indirect encoders (motor encoders), the homing status is cleared:
DB31, ... DBX60.4/5 = 0.
The spindle is in speed control mode and NC/PLC IS:
DB311, ... DBX84.7 (Openloop control mode)
is output.

Table of Contents

Other manuals for Siemens MCP 398C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens MCP 398C and is the answer not in the manual?

Siemens MCP 398C Specifications

General IconGeneral
BrandSiemens
ModelMCP 398C
CategoryControl Systems
LanguageEnglish

Related product manuals