Detailed Description
2.3 Tool cutting edge
Basic logic functions: Tool Offset (W1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
43
)
/HQJWKWRROSDUDPHWHU
) WRROKROGHUUHIHUHQFHSRLQW
Figure 2-9 Twist drill (tool type 200) with tool length (tool parameter 3)
Special points to be noted
The active size of the tool is only defined when the geometry tool length compensation (tool
parameters 3 to 5) and the wear tool length compensation (tool parameters 12 to 14) are
added together. The base-dimension/adapter-dimension tool length compensation is also
added in order to calculate the total tool length compensation in the geometry axes.
To Next Page
Loading...
Need help?
General
