Index
Basic logic functions: NC/PLC interface signals (Z1)
150 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Rapid traverse override active, 134
Read-in disable, 89
Read-in enable is ignored, 100
Recall alarm cleared, 21
Reference point approach delay, 113
Reference point value 1 to 4, 112
Referenced/synchronized 1, 113
Referenced/synchronized 2, 113
Referencing active, 111
Repos DEFERAL Chan, 105
REPOS Delay Ackn, 106
REPOS offset, 106
REPOS offset valid, 106
Repos Path Mode Ackn0-2, 103
REPOSDELAY, 105, 107
REPOSMODEEDGE, 92
REPOSMODEEDGEACKN, 103
Reset, 92
Re-synchronize spindle when positioning 2 and
1, 118
Resynchronizing spindles 2 and 1, 117
Revolutional feed rate active, 143
Rigid tapping is active, 126
RMB, 92
RME, 92
RMI, 92
RMN, 92
RMNOTDEF, 92
RS-232-C external, 16, 23
RS-232-C off, 17, 23
RS232C on, 17, 24
RS-232-C stop, 23
RS-232-C Stop, 16
S function for spindle, 129
Screen bright, 12
Screen is dark, 20
Second software limit switch plus or minus, 68
Select gear stage, 122
Selected JOG mode, 84
Selected machine function REF, 85
Selected mode AUTOMATIC, 83
Selected mode MDA, 84
Selected mode TEACH IN, 84
Selection, 18, 25
Sensor for fixed stop, 72
Set gear stage A to C, 123
Setpoint direction of rotation,
counter.clockwise/setpoint direction of rotation,
clockwise, 120
Setpoint speed increased, 125
Setpoint speed limited, 124
Setting-up mode active, 47
ShopMill control signal, 16
Simulation selected, 21
Single block type A, 83
Single block type B, 83
Skip block, 89
Speed controller active, 45
Speed controller integrator disable, 42
Speed controller integrator disabled, 51
Speed limit exceeded, 124
Speed setpoint smoothing, 39
Speed setpoint smoothing active, 48
Spindle in position, 128
Spindle in set range, 126
Spindle override, 141
Spindle positioning, 122
Spindle reset/Delete distancetogo, 114
Spindle start clockwise rotation, 121
Spindle start, counter-clockwise, 122
Spindle stop, 121
Spindle/no axis, 123
Stop at the end of block with SBL is
suppressed, 100
Switch over MCS/WCS, 21
Synchronized Actions (S5, H2)|Signals for dynamic
M functions: M0 - M99, 78
T function 1, 76
Tool offset selection, 15
Torque limit 2, 38
Torque limit 2 active, 48
Transformation active, 96
Unload, 17, 25
Value of F help function, 78
Value of M help function, 78
Value of S help function, 78
Variable signaling function, 61
VDClink lower than warning threshold, 63
Velocity/spindle speed limitation, 68
To Next Page
Loading...
Need help?
General
