Detailed description
2.4 Drive service display (for digital drives only)
Basic logic functions: Diagnostic tools (D1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
27
Motor temperature
Display of motor temperature measured via temperature sensors.
Unit: Degrees Celsius
Display corresponds to machine datum:
MD1702 $MD_MOTOR_TEMPERATURE (motor temperature).
Speed setpoint filter 1
Status display of speed setpoint smoothing function.
State 0: No speed setpoint smoothing is active.
State 1: Smoothing of the speed setpoint as requested by the PLC using IS DB31, ...
DBX20.3
("Speed setpoint smoothing") takes effect because speed setpoint filter 1 is
configured as the low pass.
Display corresponds to IS DB31, ... DBX92.3 ("Speed setpoint smoothing active") and is
shown in an updated form as of software version 6.3 and later.
References:
/FB1/ Function Manual Basic Functions; Various Interface Signals (A2)
2. Torque Limit
Display of active torque limit
State 0: Torque limit 1 is active.
State 1: Torque limit 2 is active.
Display corresponds to IS DB31, ... DBX92.2
("Torque limit 2 active").
References:
/FB1/ Function Manual Basic Functions; Various Interface Signals (A2)
Integrator disabling
This display indicates whether the speed controller integrator is active.
State 0: The integrator of the speed controller is enabled. The speed controller
functions as a PI controller.
State 1: Deactivation of the speed-controller integrator as requested by the PLC using
IS DB 31, ... DBX 21.6
("Integrator disable speed controller") is active for the drive module. The
speed controller has therefore switched from a PI to a P controller.
Display corresponds to IS DB31, ... DBX93.6 ("Speed-controller integrator disabled").
References:
/FB1/ Function Manual Basic Functions; Various Interface Sgnals (A2)
To Next Page
Loading...
Need help?
General
