Detailed description
2.1 Velocities, traversing ranges, accuracies
Basic logic functions: Velocities, Setpoint/Actual Value Systems, Closed-Loop Control (G2)
8 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
For setting the interpolation cycle, see:
References:
/FB3/ Function Manual, Special Functions; Cycle Times (G3)
With a high feedrate (resulting from programmed feedrates and feedrate override), the
maximum path velocity is limited to V
max
.
This automatic feedrate limiting can lead to a drop in velocity over several blocks with
programs generated by CAD systems with extremely short blocks.
Example:
Interpolation cycle = 12 ms
N10 G0 X0 Y0; [mm]
N20 G0 X100 Y100; [mm]
⇒ Path length programmed in block = 141.42 mm
⇒ V
max
= (141.42 mm/12 ms)
*
0.9 = 10606.6 mm/s = 636.39 m/min
The following restriction applies to the minimum path or axis velocity:
9
ಥ
PLQ
&RPSXWDWLRQDOUHVROXWLRQ>
,QFU
PPRUGHJUHHV
@LQWHUSRODWLRQF\FOH>V@
The computational resolution is defined via machine data:
MD10200 $MN_INT_INCR_PER_MM (computational resolution for linear positions)
or
MD10210 $MN_INT_INCR_PER_DEG (computational resolution for angular positions):
If V
min
is not reached, no traversing is carried out.
'5,9(B(1&B5$7,2B180(5$>Q@
'5,9(B$;B5$7,2B180(5$>Q@
'5,9(B$;B5$7,2B'(120>Q@
,17B,1&5B3(5B00
/($'6&5(:B3,7&+
'5,9(B(1&B5$7,2B'(120>Q@
,QWHUQDOLQFUHPHQWVPP
(QFRGHULQFUHPHQWVPP
(1&B5(62/>Q@LQWHUQDOPXOWLSOLFDWLRQ
To Next Page
Loading...
Need help?
General
