Detailed description
2.2 Mode groups
Basic logic functions: Mode group, channel, program operation, reset response (K1)
18 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Global machine function for mode group
After mode selection, a machine function can be selected, which is then valid globally for the
whole mode group.
Within JOG mode
Within JOG mode, one of the following machine functions can be selected:
• REF (reference point approach)
References:
/FB1/Function Manual, Basic Functions; Reference Point Approach (R1)
• REPOS (repositioning)
References:
/BEMsl/ Operator's Guide HMI Embedded; Sec.: "Repositioning on contour with
controlled REPOS"
Within MDA mode
Within MDA mode, one of the following machine functions can be selected:
• REF (reference point approach)
References:
/FB1/ Function Manual, Basic Function; Reference Point Approach (R1)
• REPOS (repositioning)
References:
/BEMsl/ Operator's Guide
• TEACHIN (teach-in of axis positions)
References:
/BEMsl/ Operating Instructions HMI Embedded and /BEM/ Operating Instructions HMI
Embedded
TEACH IN, REPOS or REF
The selection of the machine function TEACH IN, REPOS or REF
from the operator interface is stored under:
NST DB11, ... DBX5.0 to DBX5.2 (strobe machine function)
.
The desired machine function TEACHIN, REPOS or REF
is activated under:
NST DB11, ... DBX1.0 to DBX1.2 (machine function)
.
The display of the active machine function TEACHIN, REPOS or REF can be seen in the:
NST DB11, ... DBX7.0 to DBX7.2 (active machine function)
.
To Next Page
Loading...
Need help?
General
