Detailed description
2.6 Block search Type 5 SERUPRO
Basic logic functions: Mode group, channel, program operation, reset response (K1)
54 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Controlling SERUPRO behavior
Machine data:
MD10708 $MN_SERUPRO_MASK
can influence the SERUPRO behavior as follows:
Stop at M0 during search phase.
Bit 0 = 0 NC is stopped at M0 during the search phase.
Bit 0 = 1 NC is not stopped at M0 during the search phase.
Allow part program command "START" if alarm 16942 is issued.
Bit 1 = 0 The alarm aborts the search phase during part program START.
Bit 1 = 1 The alarm is suppressed. In channel i, a program uses the part program
command "Start(j)" per the following sequence:
In channel j, the preselected program is started.
Channel j begins to actually start with moving axes.
In channel j, program test can be preselected by the user
. Channel j will now not select a search target.
Bit 2 Reserved
SERUPRO not ended simultaneously.
Bit 3 = 0 Switches the function off. All channels that find the search target (also for
self-acting SERUPRO) end SERUPRO at the same time.
Bit 3 = 1 SERUPRO ends as soon as the simulation has found the search target.
No further synchronization operations take place in the channels started
by SERUPRO.
To Next Page
Loading...
Need help?
General
