SIM5300E AT Command Manual V1.02
Write Command
AT+CMOD=[<mode>]
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <mode>
0 single mode (default)
1 alternating voice/fax
2 alternating voice/data
3 voice followed by data
4 data followed by voice(propriatory mode)
Reference
5.2.3 AT+CPOWD Power Off
AT+CPOWD Power Off
Write Command
AT+CPOWD=<n>
Response
[NORMAL POWER DOWN]
Parameter <n>
0
Power off urgently (Will not send out NORMAL POWER
DOWN)
1 Normal power off (Will send out NORMAL POWER DOWN)
Reference
5.2.4 AT+CADC Read ADC
AT+CADC Read ADC
Test Command
AT+CADC=?
Response
+CADC: (list of supported <status>s),(list of supported <value>s)
OK
Read Command
AT+CADC?
Response
+CADC: <status>,<value>
OK
Parameter <status>
1 Success
0 Fail
<value> Integer
0-1200
To Next Page
Loading...
